Professional Canon EOS M2 Repair
Why Choose Us for Canon EOS M2 Repair
We fix what others couldn’t — or can’t.
Same-Day Repair
Original Parts
1–3 Month Warranty
Professional Team
Canon EOS M2 Service Prices
Prices exclude parts. We repair at the component level whenever possible. Express queue available.
- Diagnostics – $0 with repair / $50 if declined
- Express repair (2–3 hours) – +50% of selected service
- No power / won’t turn on (power-rail diagnosis) – from $140
- LCD display module replacement – from $120
- Touchscreen/digitizer replacement – from $115
- Top cover / rear shell replacement – from $155
- Sensor cleaning (wet swab + dust map) – from $60
- Body deep clean (ports + exterior) – from $50
- SD UHS-I card slot pin repair – from $85
- USB / HDMI port replacement – from $100
- Shutter unit replacement – from $165
- Main board / power circuit repair – from $140
- Hot shoe repair – from $95
- Lens mount & bayonet rebuild – from $110
- Firmware recovery / stuck on logo – from $90
Final cost depends on damage and parts. Every service includes testing and a written warranty.
Typical EOS M2 Issues We Fix
- Won’t power on after storage or charging; LP-E12 or power-board faults.
- Err 70 after moisture or bad SD; requires board/firmware diagnostics.
- Long-take overheating icon; thermal interface renewal and stress tests.
- Touchscreen misalignment or dead zones; digitizer or flex repair.
- EF-EOS M adapter comms errors; contact cleaning, mount alignment, adapter guidance.
EOS/M-Series Error Codes — Quick Hints
| Code | Meaning | Try First |
|---|---|---|
| Err 20 | Mechanical fault | Power cycle; remove battery/lens; service shutter if it repeats. |
| Err 30 | Shutter problem | Fresh battery; inspect blades; likely shutter replacement. |
| Err 40 | Power/electrical | Check contacts; avoid hot-plug; board diagnostics. |
| Err 70 | Data/processing | Reset; new SD; firmware/board rework if persistent. |
| Err 80/99 | Image/general fault | Stop use; full diagnostics to isolate sensor/firmware path. |
Pro Tips for EOS M2
- Use UHS-I U3 SD cards; format in-camera.
- Use short, quality HDMI cables; avoid strain on the port.
- For long recordings, lower bitrate or frame rate and allow cool-down intervals.
- Use genuine LP-E12 batteries; check charger blink codes before reuse.
- Keep hot shoe and EF-EOS M adapter contacts clean; reseat if comms errors appear.
FAQ – Canon EOS M2 Repair
1. Does the M2 record 4K?
No. Maximum is 1080p. We optimize settings and thermal performance for long takes.
2. The camera won’t power on.
We test LP-E12, charger comms, fuses, and power rails, then rework or replace the board as needed.
3. Touchscreen is unresponsive.
We check flexes and connectors, replace the digitizer if required, and calibrate input.
4. Lens communication errors with the EF-EOS M adapter.
We clean contacts, update firmware where applicable, and align the mount to restore reliability.
5. Does the M2 have IBIS?
No. Use lens IS or stabilize in post; we verify sensor seating and mount alignment if frames tilt.